User`s manual

Network Video Server User’s Manual
Seyeon Tech Co., Ltd
79
[e-mail]
.
2.3.3 UART(Universal Asynchronous Receiver Transmitter) device
By-pass command mode is supported by the system so that user can send command
string to target device through the server from the remote area.
By-pass command string can be sent either by third party application program or control
panel inside of the system.
A. By-pass command string from third party
This is to send command string from third party application program to the target
device connected to the server. More about this function can be supplied by HTTP
CGI API guide.
B. Control panel inside of the system
You can create control panel of external device inside of the server and control
target device through server web page.
This function is not for general use. Thus, if you need more information about this,
please contact your local distributor or manufacturer for further information,
[e-mail]
.
2.4 Voice Kit Connection and configuration
G.723.1 which is international standard for VOIP (Voice Over IP) communication based
FW-V10s voice kit can work with FlexWATCH
TM
server and you can enjoy not only live
video stream but also full duplex two real time Voice through web browser or proprietary
application program.
Voice broadcasting for voice connection by multiple users is also supported by the
system as well.
) Note
Once Multi user connection is enabled, only root Account user can enjoy full duplex audio
and rest of users can listen only.
1) Connect RS-232 Serial Cable with FW-V10S to COM port of FlexWATCH
TM
server.
Serial cable is provided with FW-V10S. Refer to PIN out diagram above.
- INTPLUS [2005] -