User`s manual

Network Camera Server User’s Manual
Seyeon Tech Co., Ltd
96
4.2 FTP service configuration
Once you get a good understanding of “Pre/post alarm buffering”, “Condition”, “FTP
directory & Name option” and “Sequence & Overwrite option” from above chapter,
now you can easily configure FTP service function.
) To begin with, you must create ’Base directory’ in your FTP server. FTP
images will be basically stored in it.
WARNING!!!
All the following steps must be configured in order. If any steps are missed or
out of order, the system will not work promptly.
4.2.1 Buffered FTP service configuration
Buffered FTP means that rising or falling edge based ftp will be done when there is any
event and only pre/post alarm buffered image can be sent to FTP server.
1) Go to ‘Advanced Services – Buffering Service’ menu.
Set up Pre alarm buffering configuration for FTP service.
2) Go to Advanced Services - Buffering Service – FTP(Buffered) – Camera1 – Condition1
menu. Set up the condition as you mind to design.
(Up to 3 different conditions can be applied to each camera.)
3) Go to ‘Camera1’ menu. Set up the number of Pre and Post alarm images and delay unit.
4) Go to ‘FTP (buffered)’ service configuration menu and set up the configuration as
below.
- INTPLUS [2005] -