User`s manual

Network Camera Server User’s Manual
Seyeon Tech Co., Ltd
73
A. By-pass command string from third party
This is to send command string from third party application program to the target
device connected to the server. More about this function can be supplied by HTTP CGI
API guide.
B. Control panel inside of the system
You can create control panel of external device inside of the server and control target
device through server web page.
This function is not for general use. Thus, if you need more information about this, please
contact your local distributor or manufacturer for further information,
[e-mail]
.
2.4 PTZ device connection and configuration
PTZ(Pan/Tilt/Zoom) device connected to the server can be controlled through either
standard web browser or specific application program over IP network.
2.4.1 PTZ connection
¾ When you install a RS-485 interfaced PTZ model:
PTZ device has to be connected to
Pin No. 1(+) and 4(-) from AUX Port.
¾ When you install a RS-232 interfaced PTZ model:
PTZ device has to be connected to
Pin No. 2(Rx), 3(Tx) and 5(GND) from AUX Port.
1) Connect your PTZ device into AUX port as above explanation.
2) Go to Admin Menu >> System Configuration >> Serial Ports Configuration.
3) Select ‘PTZ’ at AUX mode, and click ‘Apply’ button.
485
485
AUX port
8 7 6 5 4 3 2 1
GND Tx
AUX
8 7 6 5 4 3 2 1
- INTPLUS [2005] -