User`s manual

Network Camera Server User’s Manual
Seyeon Tech Co., Ltd
30
Description of Window
Menu Description
A Serial No. (MAC Address)
of System
Enter FlexWATCH
TM
server Serial No. (Mac
address) attached at the bottom of the unit and
select the LAN port.
WAN PORT is only for setting up FW-5000 and
FW-5440 model which has two LAN Card inside of
the box.
IP Address on PC Auto scanned IP address of user’s computer with
IPInstallationWizard.exe running on.
B
IP Address Input an IP address to be assigned to
FlexWATCH
TM
server
Note that the IP must be directly connectable
with user’s PC. The above IP ’10.10.225.100’ is
only an example.
C IP, Subnet, Gateway Whether to change IP, Subnet and Gate or IP and
Subnet mask only.
D ‘Set IP Address’ Button To activate a new IP assignment, click this
button.
E ‘Save IP Address’ Button To save IP-Address in the Flash Memory.
F ‘Go to Home Page’ Button To launch FlexWATCH Web browser and start
other configuration through Administration page.
G ‘Telnet to System’ Button To guide you Telnet mode for Advanced
Configuration.
H Result window Show the result of IP assignment. If failed, try
again from the start or use other configuration
method
3) Input the Serial No. (MAC address) and Select “LAN Port”.
4) Input the IP address, which will be assigned to the system.
5) Click “Set IP Address” button to save the above configuration.
6) Check whether message type is correctly appeared on Result window as below.
------------ Set Server IP Address ------------
ARP: Adding static entry to ARP table [ OK ]
Ping: Trying ping 10.10.225.100 [ OK ]
ARP: Deleting static entry from ARP table [ OK ]
7) If message come up as below, IP address setting has been failed.
- INTPLUS [2005] -