User`s manual

M4029-08 81 Seyeon Tech Co., Ltd
7.2. microSD Configuration
If a microSD card (SD card) is not present in the slot already, turn off the FlexWATCH network
camera before inserting a SD card. Make sure to turn the power on after inserting the SD card. Open
a web browser, type in the IP address of the FlexWATCH network camera. Log in as admin, and run
Recording Configuration.
Enter Recording Configuration menu, then click the SD Information to find out the SD card’s format
information.
If entire SD Information is shown as -None-, that means the SD card is not formatted. In that case,
click the Back button followed by clicking SD Status & Format.
Note: Be sure to turn off the device before installing a SD card. Otherwise, the SD card
may become defective. Always check the recommended type of SD card because
non-conforming SD cards can cause abnormal behavior of the system.