User`s manual

M4029-08 59 Seyeon Tech Co., Ltd
In Image quality level setup, selecting the left results in higher image quality, but requires higher
network bandwidth. Selecting the right requires lower network bandwidth, but gives degraded image
quality.
• Hue: Set the color of image between -100 and 100.
• Saturation: Set the intensity of the image between -100 and 100.
• Contrast: Set the contrast of the image between -100 and 100.
• Brightness: Set the brightness of the image between -100 and 100.
• Motion Sensitivity: This value sets how sensitively the motion detection works for the motion
detection functionality. It can be between –100 and 100 while 100 is the most sensitive.
• Motion Detection: This decided whether the Motion Detection is to be used. If Enable is
selected, you can set which part of the camera image the Motion Detection does functioning.
After configuration is finished, click Apply button to save the setting. If required, click Built-in
Module 1 on Device Configuration menu to set up the other channel as well.
5.3.5. Camera Setting for FW5071/FW5072
When cameras are added through the network, you can set what data to be included, camera names,
image size, and image quality.
Click the name of the camera you added, which can be found at IP Devices Registration on Device
Configuration menu.
After selecting the camera, click Camera Setting.
Set the video data format and the information to be included in the data.
• Video with UART sensor Data: If Enabled, video data will contain UART sensor data from
COM port.
• Video with user defined message: If Enabled, video data will contain the user-defined data.
(Reserved Field)
• Video with camera name: If Enabled, video data will contain the camera name.
• Video with server name: If Enabled, video data will contain the server name you defined.
• Video with IP address: If Enabled, video data will contain the IP address of the video server.
Click Apply button to save the changes.