User`s manual

M4029-08 57 Seyeon Tech Co., Ltd
• Video with UART sensor Data: If Enabled, video data will contain UART sensor data from
COM port.
• Video with user defined message: If Enabled, video data will contain the user-defined data.
(Reserved Field)
• Video with PPP status: If Enabled, video data will contain PPP connection status.
• Video with camera name: If Enabled, video data will contain the camera name.
• Video with server name: If Enabled, video data will contain the server name you defined.
• Video with IP address: If Enabled, video data will contain the IP address of the video server.
• Time Stamp: If Enabled, encoded video image will have the time display on it.
• Image Size: Select the resolution of each channel’s video data.
• Encoding Frame Rate (per channel): Video compression rate per second. You can control
the total network traffic of the server with this parameter.
• Encoding Standard: Select the compression method of each video, either M-JPEG or H.264.
Click Apply button to save the changes. If required, click Built-in Module 1 on Device Configuration
menu to set up the other channel as well.
Camera Configuration
FW3870 and FW5870 have two modules, 8 channels respectively. Each channel represent the camera
attached to FW3870 or FW5870.
On the lower part of Module 0 > Camera & Motion Configuration menu, select a channel you
want to configure.
Enter the detailed parameters of the camera selected here.