User`s manual

M4029-08 50 Seyeon Tech Co., Ltd
This menu is used to set up the selection of video format, data added to video data, encoding speed,
audio control, image resolution, video quality, motion detection, and etc.
Click Camera & Motion on Device Configuration menu, then the following window will be displayed.
Configure the video data format and other information to be contained in it.
• Default Video Format: Select the video transmission format of the camera attached to
FlexWATCH Server. Select one from NTSC or PAL.
• Video with UART sensor Data: If Enabled, video data will contain UART sensor data from
COM port.
• Video with user defined message: If Enabled, video data will contain the user-defined data.
(Reserved Field)
• Video with PPP status: If Enabled, video data will contain PPP connection status.
• Video with camera name: If Enabled, video data will contain the camera name.
• Video with server name: If Enabled, video data will contain the server name that you
defined.
• Video with IP address: If Enabled, video data will contain the IP address of the video server.
• Audio: Select if Audio function is to be used (applies to Primary Stream only). FlexWATCH
Server provides 2-way audio streaming by combining microphone input with video data. Users
can listen to the streamed audio on PC speakers.
• Encoding Frame Rate (Per Channel): Compression speed every second. This attribute
applies to all the channels. You can control the server’s total traffic with this parameter.
Note: The image size of Primary Stream is the maximum size of the Secondary Stream,
because Secondary Stream’s video soFlxwatche is the output of the Primary
Stream.
Note: For Dual Stream products, most of parameters are dependent on primary stream
value.