User`s manual

M4029-08 45 Seyeon Tech Co., Ltd
In the example shown below, Primary Stream is set to M-JPEG, and Secondary Stream set to H.264
for compression format. Enter detailed parameters of the camera selected here.
When the image sensor is VGA CMOS/CCD or 1.3M CMOS/CCD, there will be no Hue, Saturation,
Contrast, or Brightness setting items shown. Only with NTSC or PAL will those parameters be
configured.
• Camera Name: Enter the name of the channel in up to 21 alphanumeric or up to 10 Unicode
letters.
Image Quality Setup
In Image Quality level setup, select the left for higher image quality, but it requires higher network
bandwidth. Selecting the right requires lower network bandwidth, but gives decreased image quality.
After configuration is finished, click Apply button to save the setting. If you click Default button, the
entire configuration will be reset to the original values.
Camera Control for FW1173-MS, FW1173-FS, FW1174-MC, FW1175-MS, FW1175-FS,
FW1176-MS, FW1176-FS, FW1179-MV, FW1179-FS (All “-E” model)
Select Camera Control on the bottom of Camera & Motion Configuration menu.
H.264
Rate Control Mode: VBR (Variable Bit Rate)
Video frames are encoded with selected image
quality and GOP. Encoded frames have
different data size from each other.
Image Quality: one of 6 quality levels
(Low Compression / Highest / High
Normal / Low / Lowest)
GOP Structure: Distance between I-
Frames. That is filled with P-frames.
Rate Control Mode: CBR (Constant Bit Rate)
Video frames are encoded with selected image
quality and GOP. Encoded frames have the
same data size as other frames. Due to the
constant bit rate, it has better stable
transmission performance.
Bit Rate Control: Total number of Bits
encoded per second. The higher Bit Rate,
the better image quality. Can be set
between 32kbps and 2Mbps.
GOP: Distance between I-Frames. That is
filled with P-frames.
M-JPEG -
Image Quality: one of 6 quality levels
(Low Compression / Highest / High
Normal / Low / Lowest)
Low Compression Highest High Normal Low Lowest