User`s manual

M4029-08 43 Seyeon Tech Co., Ltd
5.3. Camera & Motion
This menu is used to set up the selection of video format, data added to video data, encoding speed,
audio control, image resolution, video quality, motion detection, and etc.
Click Camera & Motion on Device Configuration menu. The configuration menu will be displayed,
and it may be different between FlexWATCH models.
• H.264: In this format, each frame data is related to other nearby frames. For this reason, it
provides much higher compression ratio than M-JPEG and is adequate for video transfer.
However, if network condition is not very good and having dropped frames in video data, the
video quality can be relatively low. With FlexWATCH server, you can set the number of P-frames
in the video which is independent still images between I-frames.
• M-JPEG: This format requires much higher network bandwidth than H.264 compression. But
because of its higher quality of still image, it is adequate for detailed reviewing of stored video.
5.3.1. Camera & Motion for FW1170-VO/FW1173-MS/FW1173-FS/FW1174-VC/FW1174-
MC/FW1175-MS/FW1175-FS/FW1176-MS/FW1176-FS/FW1177-FP/FW1179-
MV/FW1179-FS (All “-E” model)
You can configure the video data format and other information to be contained in it.
Note: For Dual Stream products, the most of parameters are dependent on primary
stream value.