User`s manual

M4029-08 30 Seyeon Tech Co., Ltd
Service
Enable: Start RTSP service
Disable: Stop RTSP service
RTSP Port
In normal case, use default port number 554 to connect to RTSP service.
If not using port 554, enter the port number you want to use.
e.g.) port number 445==> rtsp:// network video server ip
address:445/cam0_0
RTP Start Port
The starting number of the port for video transfer. Each time video
transfer connection is made, the port number also increases.
Multicast
Address
Address for multicast video transfer.
The multicast address 0.0.0.0 is for stopping multicast.
Multicast Port Port number for viewing the video with a multicast address
To use ONVIF protocol, RTP/RTSP must be enabled.
4.10. SNMP Setup for Cameras and FW3170
SNMP (Simple Network Management Protocol) is a protocol to monitor and configure network status
of a network device. SNMP V1 and V2 are supported over MIB2 standard, and few functions are not
supported.
SNMP Trap can function when SNMP V1/V2 is enabled.