User`s manual

M4029-08 21 Seyeon Tech Co., Ltd
4. Network Configuration
Configuration the network is dependent on how an IP address is assigned in Ethernet-based
environment, which is static IP, dynamic IP (DHCP), or PPPoE. For wireless LAN, additional
configuration is necessary to have a connection with wireless AP.
In the case of wireless models, users have to choose between wired or wireless connection. In other
words, both connections can’t be used at the same time. The way how to choose one of them is
whether wired LAN cable is plugged into the product. When LAN cable is plugged in for longer than 5
seconds, the wired LAN is activated for data transmission. If LAN cable is unplugged more than
5secconds, wireless LAN is activated instead. If PPPoE is selected by user, wired LAN will be activated
regardless of condition of LAN cable. For network configuration, select Network configuration from
Admin page.
To make a connection to the Internet, it is required to figure out the type of the Internet service
you’re using. Depending on the service type, the network configuration can be in any of Static IP,
DHCP Client, or PPPoE. You need to set up the FlexWATCH Server according to your network type.
4.1. Network Configuration
4.1.1. Static IP Configuration
Selecting Network Configuration under Network configuration will show variables. Below picture is for
products without wireless LAN.
Note: For wireless models, additional options will be shown. Please refer to 오류! 참조
원본을 찾을 수 없습니다.오류! 참조 원본을 찾을 수 없습니다..