User`s manual

FlexWATCH User Manual Part 3
4029 30 INTPLUS
3.4.2. PPP Client (Dial-Out)
This mode is that FlexWATCH® works as a PPP Client. You can connect to the Internet or other PPP
Server through the Modem installed at FlexWATCH® (RS-232).
1. Please select “PPP Client” in “WAN (PPP, Modem)” menu.
2. Enter Telephone number in PPP Server field.
3. Enter User ID provided by ISP.
4. Enter User Password provided by ISP.
5. Enter DNS Server IP recommended by ISP.
6. Enter AT command for initializing the communication. (Initializing command is normally ‘AT’.
But it may sometimes vary based on modems. Please refer to the modem manual for the
recommended command for your modem.)
) ‘3COM U.S.Robotics 56K’ modem is recommended.
3.5. Bandwidth Control
You can control the bandwidth for FlexWATCH® Server. If out-going data is more than network
bandwidth limit, FlexWATCH® will throw away some network data packets.