User`s manual

FlexWATCH User Manual Part 3
4029 63 INTPLUS
6.2. Recording Configuration
You can configure recording conditions for each camera such as motion detection recording, 24 hours
recording, schedule recording, event recording, etc. If you have cameras registered by “RX Module
Registration”, you can also record images from those cameras.
6.2.1. Recording Configuration
When you click “Recording Configuration”, you can see available server list for recording. For example,
if FW5450 has 2 FW3450s registered to “RX Module Registration”, VS Module ID shows you 3 servers in
the list. Therefore, FW-5450 can record not only its 4 cameras but also other remote cameras attached
the other FlexWATCH Server registered to FW-5450. Below is the example of motion detection recording
setting.
1. Click “Recording Configuration” in Recording Configuration menu.
2. This menu shows you the list of VS Module ID, Server name, Connection Type, server IP
address, and MAC address. You can configure each camera of VS modules. Below is the
case that you select “Server Module 0” and select cameras connected to FW-5450 for
recording configuration.
3. “Server Module 0” refers to FW-5450 itself. Thus it shows you 4 cameras which can be
configured. You can configure each camera by selecting it. If you want to configure the
Camera 1, then Click “Camera 1”.