User`s manual

FlexWATCH User Manual Part 3
4029 57 INTPLUS
4.6. Input/Output Setup [FW-3450 & FW-5450 Only]
FW-3450 & FW-5450 provide you with 4 serial input and output ports. For example, you can connect a
sensor to serial input and a flashing light to serial output. In this case, you first install the physical devices
and assign names to serial devices so that you can distinguish them later when you have many FlexWATCH
servers.
You can enter Input Name and Output Name with up to 31 alpha-numeric letters or up to 15 Unicode
letters. After entering names, please click “Apply” button.
4.6.1. Input / Output Type Configuration
z Please select Normal Open Type for normal open type sensor connected to DI. Normal Open
means that a switch normally is off and when an event is occurred the switch turns on.
z Please select Normal Close Type for normal close type sensor connected to DI. Normal
Close means that a switch normally is on and when an event is occurred the switch turns off.
) Please select Input Type in accordance with Sensor Type and select Output Type in accordance
with Alarm’s working type. Specially, if you physically don’t use DI, please select Normal Open for
Input Type.