User`s manual

FlexWATCH User Manual Part 3
4029 54 INTPLUS
z Camera Install: When a camera is connected to FlexWATCH server, if you select Enable you
can see images from Camera, otherwise, you can’t see images from camera.
z Video Source: If you select Gray, the images from camera will be in Gray mode.
z Image Quality settings
Image Quality
You can control 6 levels (Low Compression, Highest,
High, Normal, Low, and Lowest).
Rate Control Mode : VBR
(Variable Bit Rate)
: A Frame is made based on
Image quality & GOP Structure.
Frame sizes vary depending on
bandwidth.
GOP
Length between I-Frame and next I-Frame. P-frames
are filled up between them.
Bit Rate Control
Total number of bits being encoded in a second. The
bigger Bit Rates, the better image quality.
MPEG
Rate Control Mode : CBR
(Constant Bit Rate)
: A frame is made based on Bit
Rate Control and GOP
structure but the size of frames
is the same.
GOP
Length between I-Frame and next I-Frame. P-frames
are filled up between them.
JPEG
Image Quality
You can control 6 levels (Low Compression, Highest,
High, Normal, Low, and Lowest).
z Image Quality: Compressed Image quality.
Low
Compression
Highest High Normal Low Lowest
9 Going left means better image quality with higher network bandwidth. .
9 Going right means less network bandwidth with lower image quality.
z Hue: You can control color level of Image between –100 and 100.
z Saturation: You can control saturation level between -100 and 100.
z Contrast: You can control contrast level between -100 and 100.
z Brightness: You can brightness saturation level between -100 and 100
z Motion Sensitivity: You can control motion sensitivity under Motion Detection Area.
–The value can be between -100 and 100. (100 is most sensitive.)
z Motion Detection: If you select Enable, you can set desired motion detected area by yourself.
z After all settings have been done, click Apply button. If you click Default, all the values will be
restored with factory default values.
4. Select Enable in Motion Detection.
5. You can set motion detected area by clicking each block.