User`s manual

FlexWATCH User Manual Part 3
4029 49 INTPLUS
requires less bandwidth than M-JPEG. However, if it loses I-Frame or P-Frame due to unstable network,
it affects the motion streaming. And also it has lower quality of a still image than M-JPEG. You can
control number of P-Frames in FlexWATCH Server.
3. Click “Save” button to save new setting values.
4.2.2. Camera Configuration
Through camera configuration mode, you can adjust the video quality to meet your requirement (FW-
3450 & FW-5450 has 4 channels.) Each channel refers to cameras connected to FW-3450 & FW-5450.
1. Please click a Camera number in Camera & Motion Configuration.
2. Configure the Camera as you wish.
In case of MPEG4
In case of M-JPEG
z Camera Number: Channel number, which can’t be changed. (1 ~ 4)
z Camera Name: Channel’s name with 21 Alpha-numeric letters or 10 Unicode letters.
z Camera Install: When a camera is connected to FlexWATCH server, if you select Enable you
can see images from Camera, otherwise, you can’t see images from camera.
z Video Source: If you select Gray, the images from camera will be in Gray mode.
z Image Quality settings
MPEG
Rate Control Mode : VBR
(Variable Bit Rate)
: A Frame is made based on
Image Quality
You can control 6 levels (Low Compression, Highest,
High, Normal, Low, and Lowest).