User`s manual

FlexWATCH User Manual Part 3
4029 42 INTPLUS
z Upper Limit: Maximum value
z Lower Limit: Minimum value
z Initial String Length: Initial string length of Sensor
z Initial String Data: Initial string data of Sensor
z (Speed)Delay: Delay enable/disable selection for sensor input
z Internal process delay: Value of sensor input delay
z Sensor Aiming Position: Value of Sensor Aiming Position
z Camera Aiming Position: Value of Camera Aiming Position
z Add Vehicle length to calculate delay time: Vehicle length add/ignore selection
4.1.2. Serial Output Mode
The system supports to relay third party command to target device through Serial output device control
mode. Through this, user defined message can be reached to target device.
The system supports two different modes. One is X10 protocol for PLC (Power Line Communication)
and UART (Universal Asynchronous Receiver Transmitter) device.
By using Serial Output Mode, you can send UART (Universal Asynchronous Receipt and
Transmission) device commands to FlexWATCH® Servers. FlexWATCH® can control PTZ devices,