Specifications
56
57
Conguration menu includes all the menus for Wireless LAN setting.
4-3-4. Conguration
As shown Figure 5, this can set the parameters in “Express Setup” menu.
Discovery OEM Device Name
Congures the Discovery OEM Device Name. Name can be up to 31 characters with no spaces.
Default is OEM-Cfg1.
Radio Startup Mode
Sets the startup state for the radio.
On = Normal mode (radio attempts to associate).
Off = Radio does not attempt to associate until an explicit radio-on command is given.
Sleep = Radio immediately goes to sleep at startup. Radio will wakeup via a pass mode
connection attempt or the pm-mode wakeup command.
Default is On.
Express Setup
Figure 5 – Express Setup Web Page
WLAN Connection Type
Congures the wireless interface operation type to participate in an infrastructure or
peer-to-peer network.
Infrastructure = Infrastructure (AP) mode.
AdHoc = AdHoc (peer-to-peer) mode.
Unique AdHoc = Generate unique SSID in AdHoc (peer-to-peer) mode
based on MAC address.
Access Point = Infrastructure (AP) Access Point mode.
Default is Infrastructure.
When Infrastructure / AdHoc →
SSID
Applies the SSID used for 802.11 association. SSID can be up to 32 characters.
In Infrastructure mode, the SSID controls which AP the module connects to and affects the module’s
roaming behavior. In AdHoc mode, the SSID denes the network name for the AdHoc devices.
Only the devices with the same SSIDs can connect to each other.
any = The module associates with the AP that has the best signal quality.
(other) = The module associates with the AP matching the SSID that has the best signal quality.
Default is any.
WLAN Security Type
Selects the Wireless Security Method for Authentication and Encryption.
Disabled = Wireless security is disabled.
WEP64 = WEP with 64-bit key length (sometimes referred to as 40-bit).
WEP128 = WEP with 128-bit key length.
WPA-LEAP* = WPA CISCO LEAP. Requires LEAP username and password.
WPA-PSK = WPA Pre-Shared Key. Requires WPA Passphrase.
WPA2-PSK = WPA2 Pre-Shared Key (WPA2-Personal). Requires WPA Passphrase.
PEAP* = EAP-PEAP with tunnelled EAP authentication.
Default is Disabled.
NOTE
Security methods marked with a * are not available in AP mode.