Approval Sheet SBT-M1 Copyright © 2013 by SEWOO TECH, all rights reserved.
Revision Record Rev. No Date Item Modifications 1.0 2013. 06. 28 SBT-M1 First Issued Copyright © 2013 by SEWOO TECH, all rights reserved.
1 Operation Temperature -20℃ ~ +70℃ 2 RoHS Compliance This component can meet with ROHS compliance Copyright © 2013 by SEWOO TECH, all rights reserved.
Overview 1. Substrate : Printed Circuit Board 2. Pattern: 1) Strip Line 2) Ground 3) Via Hole 4) PSR Ink Copyright © 2013 by SEWOO TECH, all rights reserved.
Block Diagram SBT-M1 MD-4DR VCC Connector 12513WR-08A ALA931C5 UART Copyright © 2013 by SEWOO TECH, all rights reserved.
28 2? 3 Shape and Dimension 42 12 SBT-M1 FCC : WF5SBTM1 0678 16 KCC-CRM-SWP-SBT-M1 Copyright © 2013 by SEWOO TECH, all rights reserved.
Pin Map PIO Pin Name Description 1 GND Common Ground 2 GND Common Ground 3 CONTROL 4 RST 5 DTR 6 RXD UART Data Output 7 TXD UART Data Output 8 Vcc Power Supply No. Pad Type Module Control Singnal Reset Signal UART request to clear to active low Copyright © 2013 by SEWOO TECH, all rights reserved.
Top View bottom View Copyright © 2013 by SEWOO TECH, all rights reserved.
Specifications of Quality Evaluation and Reliability Test 1. Standard Electrical Characteristics Items Contents Bluetooth Specification 2.
Note: The above-mentioned values have bee obtained according to our own measuring methods and may vary depending on the circuit, in which this component is actually incorporated. You are, therefore, kindly requested to test the performance of this component t incorporating in your set. Copyright © 2013 by SEWOO TECH, all rights reserved.
FCC Information This device complies with part 15 of the FCC Results. Operation is subject to the following two conditions : (1) This Device may not cause harmful interface, and (2) This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for CLASS B digital device, pursuant to Part 15 of FCC Rules.
OEM Responsibilities to comply with FCC Regulations The SBT-M1 Module has been certified for integration into products only by OEM integrators under the following conditions: -. The antenna(s) must be installed such that a minimum separation distance of 5mm is maintained between the radiator (antenna) and all persons at all times. -. The transmitter module must not be co-located or operating in conjunction with any other antenna or transmitter.
