User's Manual

Customer
SEWOO
Date
2014.12.04
Document
BnCOM Bluetooth SPP Module UART Protocol
Doc. Ver
1.0.0
7/19
7
BnCOM Confidential Proprietary
compliance could void the user’s authority to operate the equipment.
-. Labeling
- FCC ID: WF5SBTB1 / IC : 9080A-SBTB1
The certification label of a module shall be clearly visible at all times when installed in
the host device.
A label must be affixed to the outside of the host product with the following statements:
"Contains FCC ID: WF5SBTB1"
"Contains IC: 9080A-SBTB1"
- Caution: Exposure to Radio Frequency Radiation.
To comply with RF exposure compliance requirements, a separation distance of at
least 20 cm must be maintained between the antenna of this device and all persons.
*The module is limited to OEM installation only.
OEM integrators must ensure that the end-user has no manual instructions to remove or
install the module. OEM's must comply with FCC marking regulation part 15 declaration of
conformity (Section 2.925(e)).
This module is to be installed only in mobile or fixed applications (Please refer to FCC CFR 47
Part 2.1091(b) for a definition of mobile and fixed devices).
The separate approval is required for all operating configurations, including portable
configurations with respect to FCC CFR 47 Part 2.1093 and different antenna configurations.
The SBT-B1 Module has been designed to operate with the following antenna and gains. Use
with other antenna types or with these antenna types at higher gains is strictly prohibited.
Manufacturer Type of
Antenna
Model Gain (dB)
Type of
Connector
AMOTECH Co., Ltd. Chip Antenna AMAN802012MS02 3.14
Permanent
integral