User's Manual

Customer
SEWOO
Date
2014.12.04
Document
BnCOM Bluetooth SPP Module UART Protocol
Doc. Ver
1.0.0
11/19
11
BnCOM Confidential Proprietary
57600, 115200, 230400 or 460800)
: p – Parity bit(N,E or O)
: s – Stop bit (1 or 2)
AT+CONNECTMAC=xxxx Connect to remote device with Bluetooth specific
address
: xxxx –remote device Bluetooth address(12character)
AT+SETLED=n LED enable or disable. Apply after rebooting. (0:
disable , 1 : enable)
AT+SETDEVCLASS=n,v Device of class setting
N : 0 (Un-store class), 1(stored)
V : ‘P’ (Printer Class), ‘H’ (Headset Class)
AT+GETCP Identify CP chip available
AT+GETINFO=n BT Status
: n – Status or information index (0~17)
3. NOTIFY (BT→HOST) Protocol Summary
프로토콜 설명 비고
+StartH Normal boot mode
+StartL Local iAP boot mode
+StartF Local iAP boot fail mode
+SUCCESS Success send data to iOS device
+FAILn Fail send data to iOS device n : 1 ~5
4. General RESPONSE (BT→HOST) Protocol Summary
프로토콜 설명 비고
+OK REQUEST Successfully
+ERROR<N> REQUEST Error
N =1 : BAD_HOST_COMMAND,
N =2 : BAD_HOST_COMMAND_LENGTH,
N =3 : BAD_HOST_COMMAND_PARAMETER,
N =4 : BAD_LOCAL_STATE,
N =5 : NOT_MATCHED_OR_NO_DATA,
N =6 : UNHANDLED_REMOTE_RESPONSE,