Operating instructions

Compact Operating Instructions – DOP11C
31
6
Open service menu
Operation
6 Operation
6.1 Open service menu
Proceed as follows to switch to the service menu:
1. Connect the operator panel to the voltage supply.
An hourglass appears on the screen.
2. Wait until the hourglass disappears.
3. Touch the display and keep the finger on the display until the following message ap-
pears:
"Tap anywhere on screen, or touch calibrate will start in 10 seconds"
4. Stop touching the display and then touch it again.
The service menu appears.
For detailed information on setting options, refer to the system manual.
INFORMATION
For the following procedure, a project has to be uploaded into the service menu.
8969090699