Operating instructions

Compact Operating Instructions – DOP11C

Connecting the operator panel

Installation

4.5.2 Connecting the operator panel to the frequency inverter and PC

1. Connect the operator panel to the inverter.

For detailed information, refer to chapter "RS485 connection" (page 26).

2. Connect the operator panel to the PC using the standard Ethernet patch cable.

For detailed information, refer to chapter "Ethernet connection" (page 28).

3. Switch on the PC. If the HMI Builder.PRO project planning software is not already

installed on the PC, install it now and then start the software.

4. Switch on the supply (24 V) for the operator panel and the connected frequency

inverter.

8997683979

RS485

INFORMATION

The Ethernet interface of the operator panel has an "autocrossing" function. There-

fore, there is no need for a crossover cable for a point-to-point connection.

8993640715

Ethernet