Installation Guide

Customer Service Informaon

Telephone: (800) 323-5565

Fax: (310) 533-3899

Hours: 8:30 AM – 4:30 PM (PST)

Email: Support@SevilleClassics.com

Homepage: www.SevilleClassics.com

102020

Step 6.

Remove plasc from feet and stand

UltraShield® upright.

Remove the bags to nish.

Care Instrucons

Clean with mild soap and water. Dry with clean microber towel.

Use Instrucons

Simply set the shields in place to use.

To change the orientaon of the shield:

 Remove the LONG SCREWS (E) in Step 5.

 Unclamp the feet from the panels

 Reaach to the other side and re-insert LONG SCREWS (E).

Shields can be used vercally or horizontally without issue.

Model: WEB657, 8

Thank you for choosing Seville Classics! We hope that you enjoy your new

protecve shield. Please read through this user guide for parts list, assembly

instrucons, frequently asked quesons and contact informaon.

102020

UltraShield® Acrylic Tabletop Shield

PAGE 1
Step 6. Remove plastic from feet and stand UltraShield® upright. Remove the bags to finish. UltraShield® Acrylic Tabletop Shield Care Instructions Clean with mild soap and water. Dry with clean microfiber towel. Use Instructions Simply set the shields in place to use. To change the orientation of the shield:  Remove the LONG SCREWS (E) in Step 5.  Unclamp the feet from the panels  Reattach to the other side and re-insert LONG SCREWS (E).
PAGE 2
Parts List Step 3. Lay ACRYLIC PANEL (A) flat on table. A. Panels (1) D. Gaskets (4) B. Clamps (2) E. Long screws (2) C. Feet (2) F. Small screws (4) TIP: Do not remove panels from bags. Open one side of bags to install feet. Fit bottom of panel into metal lip of the CLAMP (B). Step 4. Required tools (not included): Phillips screwdriver Slide upper CLAMP (B) onto lower clamp. Make sure panel sits above the metal lip. Please make sure you have all the parts on this list.