Instructions / Assembly

ManualsBrandsSeville Classics ManualsDesks24 in. Rectangular Walnut/Satin Bronze Laptop Desks with Adjustable Height

Seville Classics

Torrance, CA 90501 USA

www.sevilleclassics.com

WEB162_02092017

Mobile Laptop Desk Cart

Model #: WEB162

Thank you for choosing Seville Classics! We hope that you enjoy your new desk cart.

Please read through this user guide for assembly instructions, parts list, frequently asked

questions and further contact information.

Summary of content (5 pages)

PAGE 1
Mobile Laptop Desk Cart Model #: WEB162 Thank you for choosing Seville Classics! We hope that you enjoy your new desk cart. Please read through this user guide for assembly instructions, parts list, frequently asked questions and further contact information. Seville Classics Torrance, CA 90501 USA www.sevilleclassics.
PAGE 2
Parts List A. Base Frame (1) B. T-bar (1) C. Neck Frame (1) D. Top (1) E. Locking Caster (2) F. Caster (2) G. T-bar Cap (2) H. Nut (4) I. Crush Washer (4) J. Screw (8) K. Washer (4) L. Tension Knob (1) M. 12 mm Wrench (1) N. 11 mm Wrench (1) O. Allen Key (1) Please make sure you have all the parts on this list. If you’re missing parts, contact us for replacements at (800) 323-5565 or send an email to Support@SevilleClassics.com Seville Classics Torrance, CA 90501 USA www.sevilleclassics.
PAGE 3
Assembly Step 1. Assemble Base Tool required: 12 mm wrench (M) Screw the stem of the casters (F) into the base by hand. Install the locking casters (E) on the open end of the base (A). Tighten until snug with 12 mm wrench (M) Step 2. Install Neck Frame Tools required: Allen key (O), 11 mm wrench (N) Mount the neck frame (C) to the base assembly. Secure the screws (J) with the Allen wrench (O) and tighten the nuts (H) with the open-end 11 mm wrench (N).
PAGE 4
Correct Incorrect When installed correctly, the T-bar should point away from the curved table edge If T-bar is angled toward the curved edge, the installation is backwards and will slant Step 4. Install Top Insert assembled top into frame neck with curved edge facing toward user. Install tension knob (L) to secure height. IMPORTANT: Tighten the locking screw against the T-bar to prevent the desk from moving up and down by turning the tension knob (L) clockwise until snug.
PAGE 5
Use Instructions 1. 2. 3. 4. 5. Roll desk into desired position. Lock casters to prevent the table from rolling. Turn the tension knob counter-clockwise to unlock height adjustment Place hands on both sides of the top and pull up to lift; press down to lower the height Turn tension knob clockwise until snug to secure the table height FAQs Q: My table top is slanted when I install it into the base, help! A: Pull the table top assembly from the base on the desk, rotate it 180 degrees and reinsert it.