Full Product Manual

ManualsBrandsSeville Classics ManualsFurnitureAirlift Walnut Pneumatic Sit-to-Stand Adjustable Desktop Converter

Thank you for choosing Seville Classics! We hope that you enjoy your new sit-to-stand

desk. Please read through this user guide for parts list, instrucons, frequently asked

quesons and contact informaon.

Model #: OFF65807, OFF65808

AIRLIFT™ Pneumac Sit-to-Stand

Adjustable Desktop Converter

09-2017 09-2017

,OFF65840

Summary of content (4 pages)

PAGE 1
AIRLIFT™ Pneumatic Sit-to-Stand Adjustable Desktop Converter Model #: OFF65807, OFF65808 ,OFF65840 Thank you for choosing Seville Classics! We hope that you enjoy your new sit-to-stand desk. Please read through this user guide for parts list, instructions, frequently asked questions and contact information.
PAGE 2
Parts List Use Instructions 1. Pull up on both AIRLIFT™ levers and desktop to lift. 2. Pull up on both AIRLIFT™ levers and press down on desktop to lower. A. AIRLIFT™ Desk (1) FAQS Q. Can I attach a monitor stand to it? What about dual monitors? A. Yes! Be sure the desk is below it’s 33 lbs. maximum weight limit. Q. What size is the base? A. Base measures 32.75 inches wide and 22 inches deep. B. Brackets (2) Q. Do I need to plug it in? A. Nope! It’s fully pneumatic.
PAGE 3
Safety Assembly Instructions Failure to follow these instructions may result in property damage or personal injury STEP 1. Remove AIRLIFT™ DESK (A) from box and set on flat table. Weighs 52.3 lbs. Requires 2 people to lift DO NOT place devices on desk edge. DO NOT route wires through desk legs. STEP 2. Cut the plastic ties on both sides of the AIRLIFT™ DESK (A). STEP 3. Flip TRAY (C) upside down. Attach BRACKETS (B) to underside of TRAY (C) with SCREWS (G) and screwdriver.
PAGE 4
STEP 4. Hook BRACKETS (B) over the bolts on the inner legs of the AIRLIFT™ DESK (A). Tighten bolts clockwise with included ALLEN WRENCH (E). Cable Management STEP 5. Pull up on both AIRLIFT™ levers and desktop to lift. Organize loose cables with included ZIP TIES (D). STEP 6. Place your belongings on the desktop to finish! WARNING: DO NOT PLACE HANDS ON DESK LEGS. MOVING PARTS CAN CRUSH. 3 ALWAYS route your cables through the REAR of the desk. NEVER route cables through the legs of the desk.