Installation Guide

2
All glass block panels are non-load bearing, so adequate
provisions must be made for support of construction around
the panel.
The materials required for all Seves Glass Block installa-
tion methods are:
• Seves Glass Block for project
• Horizontal Spacers
• Vertical Spacers
• Glass Block Silicone Sealant
• Joint Finish — Grout or Silicone
• Grout Sealer (grout finish only)
•
#
6 x 1” Flat Head Galvanized or Stainless Steel Screws
Note: If using 12” glass block, cut 11-1/2” pieces from the horizontal spacers to
make vertical spacers.
Installation Method
#
1 (Channel Construction) also requires:
• Perimeter Channel
• ProVantage
®
Anchors
Installation Method
#
2 (Anchor Construction) also requires:
For Grout Finishing you will also need a rubber float, bucket,
tile/grout sponge, and cheesecloth.
Tools required for installing the glass block are a utility
knife, screwdriver, 2-foot level, tape measure, caulk gun,
rubber mallet, electric drill, fine-tooth saw, spoon shaped
finishing tool and razor blade.
Seves Glass Block has 4 different lines of accessories.
They are 3” and 4” ProVantage
®
, 80mm KWiK’N-EZ
®
, and
MYMINIGLASS
™
. Please choose the appropriate product
line installation accessories for the type of product line you
are installing.