How to Guide

Table Of Contents

G. The vertical spacers for AllBend

™

blocks are tapered, the spacers

for 90° blocks are ﬂat. The smaller end is placed at the back

of the AllBend

™

block. The appropriate vertical spacers are

packaged with the shaped horizontal spacers. Tridron

and sharp

corners and EndBlock

™

are standard vertical spacers.

Vertical Spacers for Shapes and EndBlock

™

Spacer required between two Allbend

™

Standard spacer or 90° sharp corner, TRIDRON

and all EndBlock

™

Flat Spacer required between a 90° Radius Corner

and standard block; or vertically in jambs.

Spacer required between AllBend

™

and standard block.

H. If your project does not have a jamb on both ends, you may need

to temporarily prop a 2 x 4 stud at the open end of the wall. Make

sure the stud is plumb. This stud will serve as a plumb point for

you to follow as you set blocks.