Instructions / Assembly
8
J. Continue inserting spacers and blocks in this manner to
complete the row. Do not apply sealant to the side of
the last block and last spacer. Insert the last block in
the side channel and slide it into the bottom channel.
N. Remove any excess sealant. If necessary, adjust the
size of the sealant beads to prevent squeeze out on the
following rows. The joint areas must be kept clean of
sealant.
blocks. If more than one section of horizontal spacer is
required, be sure to lay them end to end with the joint
directly above vertical spacer. Stagger these joints on
each following row.
blocks just behind the raised edges.
Make sure all the blocks are sitting completely in the
channel and the joints are tight.
4L
4K
4M