Installation Guide

19
3. installing the First rOw
E. Attach anchor to jamb with galvanized or stainless steel screws.
D. Then apply two 1/4” beads of sealant to the top of this same hor-
izontal spacer, 1/4” in from edge of spacer.
C. Apply two 1/4” beads of sealant to the edges of the horizontal
spacers 1/4” in from the edge of the spacer. Place spacer sealant
side down.
B. Insert an anchor into the ends of the horizontal spacer where it will
meet a vertical jamb or wall.
3B
3C
3F
A. Cut the horizontal spacers for each course to fit the opening.
3D
F. Apply two 1/4” beads of sealant to a vertical half spacer, 1/4” in
from edge of spacer. Place it in the vertical jamb, covering the
anchor. Apply sealant 1/4” in from edge of spacer.