Installation Guide

B. 90° Sharp Corner Sections

1. Cut standard spacers at 45°

2. Align spacers below block to create 90° corner.

C. Install the ﬁrst row of blocks and vertical spacers, starting with

ﬁrst block in the jamb and continuing between all blocks in the

project.

D. If your project does not have a jamb on both ends, you may need

to temporarily prop a 2 x 4 stud at the open end of the wall. Make

sure the stud is plumb. This stud will serve as a plumb point for

you to follow as you set blocks.

(test Fit the First rOw COntinued)