Installation Guide

15
Note: If it is necessary to have a joint in the horizontal spacer, to extend it to
t the width of the section, make sure the joint will align with a vertical
spacer. Stagger these joints on each following row.
3. For straight sections between a 90
0
Sharp Corner and Terminal
Lineare And Terminal Curvo, cut the horizontal spacer 3/4”
shorter than the nominal dimension.
2. test Fit the First rOw
A. Cut horizontal spacers for straight sections of the wall.
1. For straight walls between two jambs or one jamb and a shaped
block, cut the horizontal spacer 1/4” shorter than the nominal
dimension.
2A
2
2. For straight sections between one jamb and Terminal Lineare
and Terminal Curvo, cut the horizontal spacer 1” shorter than
the nominal dimension.
2A
1
NOMINAL DIMENSION
MINUS 1/4"
NOMINAL DIMENSION
MINUS 1"
2A
3
NOMINAL DIMENSION
MINUS 3/4”