Instruction manual

Version 1 2011-04-18
8
US
5. Switching on for the rst time
When you switch your device on for the rst time, it rst asks you for some basic set-
tings.
1. Plug the mains plug into the outlet.
2. Switch the device on with the on/off switch.
 The display shows:
Please select language
3. Turn the e-Select until the desired language is shown and conrm it by pressing
the e-Select.
 The display shows:
Please select water hardness
4. Check the water hardness on a tap using the water hardness test strip. To do
this, proceed according to the enclosed description of the test strips.
5. Use the e-Select to select the water hardness and conrm your entry.
 The display shows:
use filter?
6. Rinse the water tank thoroughly with water.
7. If desired, insert the “Limpid” water lter into the water tank (Fig. 2) the water tank
with cold drinking water up to the „Max“ marking and insert it into the device
(Fig. 3). Here, mre that the water tank hooks into the top of the device and lies
close against the device.
NOTE!
A water lter improves the water quality of the water used
by removing contaminants from the water. SEVERIN
recommends the use of the “Limpid” water lter for high
water quality.
8. Select with the e-Select
•
no, if you do not want to use a water lter or
•
Yes, if you want to insert a water lter in the water tank.
Fig. 2: Inserting the water lter Fig. 3: Inserting the water tank