Instruction manual

Version 1 2011-04-18
13
US
 The display shows:
quantitY
and below this a bar with the set quantity in „ml“. The coffee dispensing
stops automatically, but it can also be stopped by pressing the e-Select.
After the preparation, the display shows the following for a short while:
clean milk unit?
8. Press
• the
button to perform the cleaning (see „8.‘8.3.2 Cleaning the milk
unit’ on page 20) or
• the
button if you only want to perform the cleaning later.
NOTE!
It is recommended that you clean the milk unit after each
preparation.
6.4 Preparing coffee with coffee powder
You can also prepare a coffee specialty with coffee powder. This is especially useful if
you want to prepare a decaffeinated coffee, for example.
1. Proceed as described in the se‘6.3.1 Preparing coffee or espresso’sso“ ‘6.3.2
Preparing coffee-milk specialties’“ to select the desired beverage.
2. Instead of selecting the strength of the coffee, use the
button to select the
symbol.
3. After you have selected the desired water and milk quantities, press the e-Select.
 The display shows
Please add coffee Powder
4. Open the cover of the bean container and ll the powder dosing chamber with
coffee powder.
CAUTION!
Incorrect lling can damage the device.
– Only add coffee when the device asks you to.
– Only add coffee made of ground beans (no instant
beverage powder, coffee granules, cocoa, etc.).
– Fill the powder dosing chamber just once for a cup
portion, not multiple times.
5. Turn the powder dosing chamber over (Fig. 7).
6. Turn the powder dosing chamber back to the initial position and close the cover
of the bean container.
7. Press the e-Select again.
 The desired coffee specialty is prepared.
8. To make changes to the liquid quantities while drawing, turn the e-Select as de-
scribed in the sections ‘6.3.1 Preparing coffee or espresso’ repar ‘6.3.2 Preparing
coffee-milk specialties’