Instructions

17
Installation
∙ The appliance should be set up in a well-ventilated, dry
room.
∙ It should be operated in conditions where the relative
humidity is no more than 70 %.
∙ The product data sheet at the end of this manual
contains details of the ambient temperature range
suitable for this appliance.
∙ Do not use the appliance outdoors.
∙ Ensure that the plug is accessible and can be removed
from the wall socket at any time.
∙ Do not expose the appliance to direct sunlight, and
do not position it next to any heat sources (radiators,
cookers etc.). If this cannot be avoided, however,
suitable insulation must be in installed between the heat
source and the unit.
∙ The unit must not be installed inside a cabinet, nor
directly below a hanging cupboard, shelf or similar
object.
∙ In the case of uneven fl oors, the adjustable feet on the
unit can be used to compensate and ensure optimum
stability.
Set-up dimensions
If the refrigerator is installed with its side against a wall,
ensure a minimum clearance of 60 mm to ensure that the
door can open through 90°.
To remove the fresh-storage compartment, the bottle rack
must be taken out fi rst.
Ventilation
The heated air around the rear of the unit must be able to
circulate freely. Therefore, ensure that the air circulation
behind the unit is not obstructed.
Caution: Ensure at all times that the rear ventilation
openings around the top cover are not obstructed.
Reversible door
If required, the door may be reversed, i.e. from right-hinged
(default installation) to left-hinged.
To avoid the risk of personal injury or damage to the unit,
two people are needed to reverse the door.
Warning: Always disconnect the unit from the mains
before any maintenance or repair work is carried out.
Before you get started, please note the following:
∙ Always ensure that the correct number of washers is
used on all hinge bolts and screws.
∙ So that the doors can close tightly against the frame,
take the utmost care that they are properly aligned
during re-assembly.