Instructions

16
Before using for the fi rst time
∙ Remove any exterior and interior packaging materials
completely, including the adhesive strips.
∙ The packaging materials must be properly disposed of.
Ensure that the following accessories are included with
the appliance:
2 spacer elements
2 screw covers
1 egg-storage tray
1 large covering panel
1 small cover plate
∙ Fit the two enclosed spacer elements (1) into the
corresponding guide slots on the rear (2).
∙ Fit the covering panel (provided) below the fridge door.
∙ Before it is connected to the mains, the unit must be
thoroughly checked for transport damage, including its
power cord.
∙ Clean the unit as described in the section De-frosting
and cleaning.
∙ For positioning, we recommend that you tilt the unit
slightly backwards. In this way, the transport rollers can
be used to move it to its intended place of installation.
∙ The unit should only be transported in its vertical
position; do not tilt any more than 30°.
∙ Once the unit has been positioned, wait for about 30
minutes before it is connected to the mains.
∙ If the unit has been tilted more than 30° during transport,
allow it to stand upright for at least 4 hours before it is
connected to the mains.
∙ When the unit is fi rst switched on, a slight ‘new’ smell
may be noticed. However, this will disappear once the
cooling process has begun.