Instructions

13
Refrigerator
Dear Customer,
Before using the appliance, read the following instructions
carefully and keep this manual for future reference. The
appliance must only be used by persons familiar with these
instructions.
Transporting the appliance
To prevent damage to the unit during transport, ensure that
all accessories and components inside and around the
appliance are securely fastened.
The unit must only be transported in its vertical position; do
not tilt any more than 30°.
Once the unit has been positioned, wait for about 30
minutes before it is connected to the mains.
If the unit has been tilted more than 30° during transport,
allow it to stand in an upright position for at least 4 hours
before it is connected to the mains.
Connection to the mains supply
The appliance should only be connected to an earthed
socket installed in accordance with the regulations. Make
sure that the supply voltage corresponds with the voltage
marked on the rating label. This product complies with all
binding CE labelling directives.
∙ Do not operate this unit by means of a transformer.
∙ To prevent noise vibration, ensure that the power cord
does not touch any part of the rear of the unit
General information
∙ This appliance is a compressor refrigerator, designed for
the short-term storage of food.
∙ Refrigeration appliances are classifi ed into certain
climate classes. Please refer to the product data sheet
for information on the classifi cation for this unit; the data
sheet can be found at the end of this manual.
∙ No responsibility is accepted if damage results from
improper use, or if these instructions are not complied
with.
Important safety instructions
∙ This appliance is intended for
domestic or similar applications, such
as
- in shops, offi ces and other similar
working environments,
- in agricultural areas,
- by customers in hotels, motels etc.
and similar establishments,
- in bed-and breakfast type
environments.
∙ This appliance is not intended for
commercial use, nor for use in the
catering business or similar wholesale
environments.
∙
The cooling circuit in this
appliance contains the
refrigerant isobutane
(R600a), a natural gas
with a high level of environmental
compatibility, which is nevertheless
fl ammable. Ensure, therefore, that
none of the components of the
refrigerant circuit become damaged
during transportation and installation
of the appliance. If damage to the
cooling circuit does occur, do not
switch on or connect the appliance to
the mains power. In the case that
there is an open fi re or any other
sources of ignition in the vicinity of the
refrigerant gas, make sure it is
removed immediately from this area
and that the room is then thoroughly
ventilated.
∙ Warning: Keep ventilation openings,
in the appliance enclosure or in the
built-in structure, clear of obstruction.
Suffi cient ventilation must be ensured
at all times.
∙ Warning: Do not damage the cooling
circuit. Any escaping refrigerant
causes damage to the eyes; there is
also a danger of the gas igniting.
∙ Warning: Do n ot use any external
device (e.g.; heaters or heating fans)
to accelerate de-frosting; follow only
the methods recommended in this
manual.
GB