Instructions
27
GB GB
Adjusting the grind
CAUTION!
Adjust the grind only while the appliance is grinding
the coffee beans otherwise the grinder may be
damaged.
TIP
A ne grind is recommended for a light roast and a
coarse grind for a dark roast. The roast is normally
printed on the coffee packaging.
1. Prepare coffee with coffee beans, ►“5.1 With coffee beans” on
page 26.
2. Wait until the appliance grinds the beans.
Fig. 2: Adjusting the grind
3. Set the grind regulator
1 2 3 4 5 6 7 8 9 10 11
12
13 14 15 16 17 18
to the required grind.
• Turn the regulator clockwise towards “–” to grind the coffee ner.
• Turn the regulator anticlockwise towards “+” to grind the coffee
coarser.
5.2 With ground coffee
1. Press the “OPEN” button
1 2 3 4 5 6 7 8 9 10
11
12 13 14 15 16 17 18
on the side of the appliance to open the
swing-out lter
1 2 3
4
5 6 7 8 9 10 11 12 13 14 15 16 17 18
.
2. Place the lter insert
1 2
3
4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
in the swing-out lter
1 2 3
4
5 6 7 8 9 10 11 12 13 14 15 16 17 18
.
3. Place a disposable coffee lter in the lter insert
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
.
TIP
You can also use the permanent lter
1
2
3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
instead of
a disposable coffee lter.
4. Add the ground coffee to the disposable coffee lter. Use the supplied
measuring scoop
1 2 3 4 5
6
7 8 9 10 11 12 13 14 15 16 17 18
for this purpose. Refer to the following table for
the required amount:
Number
ofcups
Number of scoops
2 1½ – 2
4 3 – 4
6 4½ – 6
8 6 – 8
5. Fit the lter ring
1
2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
onto the lter insert
1 2
3
4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
.
6. Close the swing-out lter
1 2 3
4
5 6 7 8 9 10 11 12 13 14 15 16 17 18
.
7. Remove the coffee jug.
TIP
Do not ll the water tank higher than the desired
amount of cups requires as the entire amount of
water poured into the tank will be used for the
preparation process.