Instructions

14
104 x 142 mm
Preparing the air-extraction process
∙ Connect the appliance to the mains.
∙ Slide the connecting hose rmly onto the
suction outlet on the right-hand side of
the unit.
∙ Fit the other end of the hose to the valve
on the vacuum container.
∙ Set the valve on the container to the
vacuum position.
Air extraction:
∙ Press the CANISTER button.
∙ The CANISTER button remains lit
while the air is being extracted from the
container.
∙ Once the process is complete, the
CANISTER button light goes out and the
hose can be removed.
∙ Set the valve on the container to the
position.
∙ To interrupt the process, press the
STOP button.
∙ Disconnect the appliance from the
mains.
Opening the container
∙ To open the vacuum container, set the
valve on the container to the position.
∙ Once air is admitted, the lid can be
taken off.
Cleaning and care
∙ Before cleaning the appliance, always
remove the plug from the wall outlet.
∙ To avoid the risk of electric shock, do
not clean the appliance with liquids or
immerse it.
∙ The exterior of the housing may be
cleaned with a damp, lint-free cloth.
∙ To clean the vacuum chamber, sealing
bar or silicone gasket of any persistent
residues, allow the appliance to cool
down rst and then carefully remove the
residues with a damp cloth.
∙ The vacuum container should be
cleaned after each use with warm soapy
water; dry thoroughly afterwards. Do
not use a dishwasher.
Replacement bags and lm rolls
Any regular vacuum lm bags or rolls with
a knobbed surface structure may be used
with this appliance. This type of surface
allows optimum air extraction. The width of
the bag/roll must not exceed 30 cm.
Suitable replacement bags/rolls are
available at household stores or may
be obtained through SEVERIN Service,
quoting article no.
ZU 3613 (bags 16 x 25 cm)
ZU 3614 (bags 20 x 30 cm)
ZU 3615 (bags 30 x 40 cm)
ZU 3616 (lm roll 20 x 600 cm)
ZU 3617 (lm roll 30 x 600 cm).