Instructions for use Freezer
Freezer Dear Customer, Before using the appliance, please read the following instructions carefully and keep this manual for future reference. The appliance must only be used by persons familiar with these instructions. Connection to the mains supply The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label.
thoroughly ventilated. Warning: Do not damage the cooling circuit. Any escaping refrigerant causes damage to the eyes; there is also a danger of the gas igniting. Warning: Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction. Sufficient ventilation must be ensured at all times. Warning: Do not use any external device (e.g. heaters or heating fans) to accelerate de-frosting; follow only the methods recommended in this manual.
Familiarisation 1. 2. 3. 4. 5. Temperature control (at rear) Removable shelf Adjustable foot Door Vapouriser Before using for the first time – Remove any exterior and interior packaging materials completely, including the adhesive strips. – Before it is connected to the mains, the unit must be thoroughly checked for transport damage, including its power cord. – Clean the unit according to the instructions given in the De-frosting and cleaning section below.
6. 7. 8. 9. 10. 11. 12. 13. on the right. Ensure that the cover is firmly pushed down into the hole. Pull out the two bolts (7) which hold the lower right hinge plate (4) and the adjustable foot (6) in position. Remove the adjustable foot (8) on the left and insert it into the corresponding thread on the right. Install the lower hinge plate (4) with the two bolts (7) on the left. Replace the door in its new position. Ensure that the hinge pin is inserted into the guide bushing (hole) on the lower part.
– – – – – – – into the freezer compartments, properly spaced in one or two rows. Avoid contact with food that has already been frozen. Do not deep-freeze more than 2.5 kg of fresh food per day. Set the temperature control to 5. After 24 hours, once the food is well frozen, the temperature control can be set back to its original position. Prior to freezing, fresh food (e.g. meat, fish, minced meat) should be divided into smaller portions suitable for use after thawing).
De-frosting and cleaning After a certain period of operation and depending on several factors (e.g. how often the door has been opened), a layer of ice will form inside the freezer compartment. Once the build-up of ice has reached a thickness of 3 to 5 mm, the unit must be de-frosted. The build-up of ice increases the power consumption of the appliance. – When de-frosting the unit, ensure that the plug has been removed from the wall socket.
Problem Possible cause and solution The appliance is connected to The wall socket has no power, or there are contact problems. the mains, but does not operate. Check the wall socket and the plug. Check whether – too much food has been stored in the unit. – the thermostat is set to position 1 or 2 (in this case, set it to The unit seems to generate a suitable higher value). insufficient cooling power. – the door is not properly closed. – there is too much dust on the condenser.
detailed fault description and quoting the article number KS ... on the rating plate of the appliance (see picture). This information will help us to handle your request efficiently. Product data sheet Art. no.
Kundendienstzentralen Service Centres Centrales service-après-vente Oficinas centrales del servicio Centros de serviço Centrale del servizio clienti Service-centrales Centrale serviceafdelinger Centrala kundtjänstplatser Keskushuollot Servisné stredisko Centrala obsługi klientów Szerviz Κεντρικό σέρβις SEVERIN Service Am Brühl 27 59846 Sundern Telefon (02933) 982-460 Telefax (02933) 982-480 service@severin.de Kundendienst Ausland Belgique Dancal N.V. Bavikhoofsestraat 72 8520 Kuurne Tel.
I/M No.:8544.
