Velcro Strip Instructions

Important

Failure to follow instructions

carefully may cause damage!

Do not use with wallpaper

or hang over beds. May not

adhere well to vinyl surfaces.

Apply to surfaces above

50°F (10°C). Adhesive could

lose adhesion above 105°F

(40°C).

Velcro Strips

for Room Sensors

PAGE 1
Velcro Strips for Room Sensors Important Failure to follow instructions carefully may cause damage! Do not use with wallpaper or hang over beds. May not adhere well to vinyl surfaces. Apply to surfaces above 50°F (10°C). Adhesive could lose adhesion above 105°F (40°C).
PAGE 2
To Remove To Apply 1 Clean surface with rubbing alcohol. Do not use household cleaners. Separate strips. 2 wall for 10 seconds. 3 1 Remove Room Sensor from wall. Do not pull straight off. 2 Never pull the strip towards you! Always pull straight down. 3 SLOWLY Place your Room Sensor on the velcro Press top of strip and pull tab slowly down along the wall at least 6 inches (15cm) until strip releases.