Certifications 2

Seuthe GmbH
EG - SAFETY DATA SHEET subject to the regulations 1907/2006/EG
Product Name: Steam-Smoke-Distillate / Smoke Fluid
Generation Date: 30.05.2017
Version: 1.2
___________________________________________________________________________
Page 5 of 13
wave and current direction and speed may greatly influence the appropriate action to be taken.
For this reason, local experts should be consulted. Note: Local regulations may prescribe or
limit action to be taken.
6.4 References to other sections
See sections 8 and 13.
SECTION 7 HANDLING AND STORAGE
7.1 Precautions for save handling
Avoid contact with skin. Prevent small spills and leakage to avoid slip hazard. Material can
accumulate static charges which may cause an electrical spark (ignition source). When the
material is handled in bulk, an electrical spark could ignite any flammable vapors from liquids
or residues that may be present (e.g., during switch-loading operations). Use proper bonding
and/or earthing procedures. However, bonding and earthing may not eliminate the hazard from
static accumulation. Consult local applicable standards for guidance. Additional references
include American Petroleum Institute 2003 (Protection against Ignitions Arising out of Static,
Lightning and Stray Currents) or National Fire Protection Agency 77 (Recommended Practice
on Static Electricity) or CENELEC CLC/TR 50404 (Electrostatics - Code of practice for the
avoidance of hazards due to static electricity).
Loading/Unloading Temperature: [Ambient]
Transport Temperature: [Ambient]
Transport Pressure: [Ambient]
Static Accumulator: This material is a static accumulator. A liquid is typically considered a
nonconductive, static accumulator if its conductivity is below 100 pS/m (100x10E-12 Siemens
per meter) and is considered a semiconductive, static accumulator if its conductivity is below
10,000 pS/m. Whether a liquid is nonconductive or semiconductive, the precautions are the
same. A number of factors, for example liquid temperature, presence of contaminants, anti-
static additives and filtration can greatly influence the conductivity of a liquid.
7.2 Conditions for save storage; including any imcompatibilites
The type of container used to store the material may effect static accumulation and dissipation.
Keep container closed. Handle containers with care. Open slowly in order to control possible
pressure release. Store in a cool, well-ventilated area. Storage containers should be earthed
and bonded. Fixed storage containers, transfer containers and associated equipment should
be earthed and bonded to prevent accumulation of static charge.
Storage Temperature: [Ambient]
Storage Pressure: [Ambient]
Suitable Containers/Packing: Tank Trucks; Railcars; Barges; Drums
Suitable Materials and Coatings (Chemical Compatibility): Teflon; Polypropylene;
Polyethylene; Stainless Steel; Carbon Steel
Unsuitable Materials and Coatings: Ethylene-proplyene-diene monomer (EPDM); Natural
Rubber; Polystyrene; Butyl Rubber