Specifications

19
2. Press the cal key. The display will read “d-noS”.
3. Press the CAL key. The factory defaults will now be restored.
If any error message is displayed during the self-diagnostic test, the balance will emit
a prolonged tone. WRITE DOWN THE ERROR MESSAGE. Unplug the balance and plug
it back in. The display will read “d-noS”. Run the self-diagnostics again. If the same
message appears, call for service.
DO NOT ATTEMPT TO REPAIR THE SETRA BALANCE. IT MUST BE RETURNED TO
THE SETRA FACTORY OR TO AN AUTHORIZED SERVICE CENTER FOR PROPER
REPAIR. THE SELF-DIAGNOSTIC SHOULD ONLY BE USED TO VERIFY PROPER
OPERATION OF A BALANCE.