Specifications

WEIGHING IN THE PRESENCE OF VIBRATION

The int key can be used to enter a slow update mode for weighing in the presence of

vibration. However, the int key is factory pre-set to provide a rapid update for filling

operations. Refer to Appendix I, “Set-Up Functions” to alter the functionality of the int

key for a longer integration time. Once altered, follow the procedure below to activate

the longer integration time.

1. Press the int key to select the slow update mode. The INT symbol will be

displayed.

2. Perform any weighing procedure.

To exit this mode, press the int key again.

ASSIGNING A SAMPLE NUMBER TO A BATCH

To assign a number ( such as a test number or an account number) to a given batch,

use the following procedure:

1. Enter the number you wish to assign (up to twenty-five digits).

2. Press the sample no. key.

NOTE: Although the display will only show the last six digits entered, up to twenty-

five digits may be stored and printed as a sample number. The — key may

be used to insert dashes into the sample number.

NOTE: The number entered will be assigned to all batches until a new number is

entered. To clear a number, enter 0 and press the sample no. key.

PRINTING OUT INFORMATION

Your Setra balance is designed to print out information regarding a given batch when

connected to an optional printer. To print out information using the Setra Model 240P or

340P printer, use the following procedure:

1. Connect the printer’s AC adaptor to a 110-volt outlet.

2. Connect the other end of the adaptor to the printer.

3. Connect the appropriate end of the printer connection cord to the printer.

4. Connect the other end of the connection cord to the balance.

5. Perform the necessary functions on the balance.

6. Make sure the printer is turned on (as indicated by the printer’s green light). If

the printer is not on, press the power switch, located on the left hand side of the

printer, to the on position.