Specifications
16
Appendix I
Set-Up Functions
Your Setra Easy Count scale was programmed at the factory to operate in a
prescribed manner. Many of the factory settings can be altered by an autho-
rized Setra dealer to optimize scale performance for your counting or weigh-
ing operation. For example, the scale is factory preset to request a minimum
of 10 pieces to initiate the counting process. Your dealer can alter the
minimum to a smaller or larger sample, such as 5 or 30 pieces. Your dealer
can also alter the minimum counting accuracy, the baud rate used for data
communications, display hysteresis and print formatting.
Factory settings can also be changed by a scale operator using a Setra Auto
Count
™
200, decoding bar code scanning device (Smart Wand) or by using a
computer connected to the scale through the bi-directional RS-232 serial
data port. For information on how to use a PC, or other device, to alter
factory settings ask your dealer for the Setra Easy Count Technician’s Guide,
or request a copy from the factory.
The following scale settings are available in addition to the factory default
settings. Your dealer may change these settings to fit your particular appli-
cation and so the factory defaults may not apply.
Minimum Sample Size (pieces): 0-999
Default: 10, 25, 50 or 100
Minimum Counting Accuracy: 95-99.99%, none
Default: 95%
Baud Rate: 300, 600, 1200, 2400, 4800, 9600
Default: 2400
Parity: even/odd/none
Default: no parity
Display Hysteresis: on or off
Default: on
Display hysteresis when enabled provides
a more stable, easier to read number. Dis-
play hysteresis can be set to prevent the
last digit from changing if weight changes
are less than 1 displayed increment.