Specifications

UNLOCKING THE SAMPLE SIZE

To unlock the sample size, follow this procedure:

1. Remove all weight from the pan and press zero. “0.00” is displayed.

2. Press the sample size key (EZ6) or the count key (EZ2). The scale will

display “Add XX.”, where XX is the locked sample size.

3. Press and hold the count key for 5 seconds until the scale beeps.

5. The scale will return to weight display, “0.00”. The sample size is now

unlocked.

PRINTING OUT INFORMATION

Your Easy Count scale can print out requested or stored information regard-

ing a given batch when connected to an optional serial printer (see Appen-

dix I). The default RS-232 output from the scale is the average piece weight

(APW) formatted for a 1.25” bar code label on a CoStar SETRA250 printer.

1. Connect the printer’s AC adaptor to a 110-volt outlet.

2. Connect the other end of the adaptor to the printer.

3. Connect the 6 pin telephone jack end of the printer connection cord

to the printer’s “Input” port.

4. Connect the 9 pin end of the connection cord to the scale’s DB9 port.

5. Perform the necessary counting or weighing procedures on the scale.

6. Press the print key (EZ6) or the count key (EZ2) on the scale.

7. Repeat Steps 5 and 6 any time you wish to print out information.

NOTE: a. The print output can be changed for either printing on receipt

paper or another label format on the CoStar SETRA250 printer.

Refer to the Print Output Setup or the Easy Count Technician’s

Guide for other print formats.

b. When using a printer other than the CoStar SETRA250, set the

baud rate and parity of your scale to match the printer (see Easy

Count Technician’s Guide).