Specifications

9
SETTING FUNCTION OF MODE KEY TO PRINT OR HOLD
The MODE key may be set to either print or hold a displayed weight. The
selectable print functions are: “stable print” which will only print once a
stable reading is attained, “interval print” which may be programmed to
print at predetermined time intervals, “instant print” which will print imme-
diately after the MODE key is pressed (note: the reading may not be stable).
The number of line feeds may also be set for label printing. The print func-
tion is set separately from the line feed setup, i.e., set the print function first
then re-enter the print menu to program the number of line feeds. The MODE
key can also be set to the hold feature in which the balance attains a stable
weight and locks it in the display until a key is pressed.
To set the function of the MODE key, use the following procedures:
STEP 1:
TARE
POWER
MODE
SPAn
0.00
Hold down the TARE key then press the MODE key. Release both keys, the
display will read “SPAn”.
STEP 2.
MODE
TARE
POWER
FUnC
SPAn
Press the TARE key again and the display will read “FUnC” for function.
NOTE: To escape anytime during this procedure, press the TARE key until
“ESCAPE” is displayed, then press the MODE key.
STEP 3.
PrIn7FUnC
MODE
TARE
POWER
Press the MODE key to enter the function menu. The display will read “PrInT”.
Proceed to step 4a. to program the MODE key to perform a print command.
Go to step 4b. to program the MODE key to perform the hold function.