Product specifications
Phone: 800-257-3872 • Fax: 978-264-0292 • setra.com ©2014 Setra Systems, Inc. All rights reserved. The Setra Systems name and logo are registered trademarks of Setra Systems, Inc.
DIFFERENTIAL PRESSURE
4
Absolute Pressure — Pressure measured relative to full vacu-
Atmospheric Pressure — Pressure of the atmosphere at the
earth’s surface NIST standard atmospheric pressure = 1.01325
bar.
BAR -
cury at 0°C, at 45°.
Barometric Pressure — Atmospheric pressure, often measured
Burst Pressure — The maximum pressure that may be applied
to the positive pressure port without rupturing the sensing ele-
ment.
Capacitive Sensing — Detection and measurement of pressure
through the change in voltage across a capacitor, one plate of
which is a diaphragm which deects slightly with changes in
applied pressure.
Compound Pressure — Pressure measured from full vacuum
Dierential Pressure — Pressure measured relative to a refer-
ence pressure. Referred to as pounds per square inch dieren-
FS (Full Span or Full Scale) — The range of measured values
over which a transducer is intended to measure, specied by
Gauge Pressure — Pressure measured relative to ambient
atmospheric pressure. Quantied in pounds per square inch
Manometer — An early instrument for measuring pressure;
-
other closed or connected to a registering or recording instru-
ment. Modern versions utilize diaphragms, bellows or other
devices for sensing relative pressures.
Millibar (mbar) — Unit of pressure generally used in barometric
2,
2
.
Newton (N) — The unit of force in the International System of
2
to a mass of 1 kg.
Pascal (Pa)
2
P/I
Pressure Transducer — An electromechanical device for translat-
ing uid pressure values into voltages across a high-impedance
Pressure Transmitter — An electromechanical device for trans-
into a low-impedance load.
Proof Pressure — The maximum pressure that may be applied
PSIA — Pounds per square inch absolute.
PSIV — Pounds per square inch vacuum.
Range — The spread between the maximum and minimum
pressures between which the transducer has been designed to
operate.
Span — The algebraic dierence between the limits of the range.
-
Vacuum — Generally refers to pressures between 0 and atmo-
Relative Humidity — Relative humidity is a measurement of
water in the air at a given temperature.
Relative Humidity Accuracy — RH accuracy is the error between
the actual RH and the RH indicated by the humidity sensor,
Relative Humidity Repeatability — Repeatability is the ability of
the sensor to reproduce the output when moving in one direc-
tion, either from low to high RH or high to low.
RH Sensor Interchangeability — Interchangeability is the %RH
error introduced when replacing a sensor tip with a new sensor
tip.
RH Long Term Stability — Long term stability is the %RH error of
the sensor over time.
RH Sensor Recovery from Condensation — Recovery after
exposure to condensing conditions. Sensor should self-recover
after the moisture on the surface evaporates.
RH Sensor Recovery from Chemical and Physical Contaminants
— Sensing surface coated with a micro-pourous metal electrode,
allowing the polymer to absorb moisture while protecting it from
contamination and exposure to condensation
Current Sensor — A Current Sensor is a device that detects elec-
-
tional to it.