Specifications

Appendix B Super II 107
To produce the ASCII output below, enter the following script by using the numeric keypad followed by
the CODE soft key for each code. For alphanumeric characters, enter a single character and press the
ENTER key. To look up the numeric code associated with each character or scale function, refer to the
tables on page 116 through 120.
Part #: 123-456
APW: +2.56789 G
SCRIPT - Part #: (ID 0 is default register) <CR><LF>
CODES - 80 CODE, 97 CODE, 114 CODE, 116 CODE, 32 CODE,
35 CODE, 58 CODE, 32 CODE, 128 CODE, 13 CODE, 10 CODE
SCRIPT - APW: (APW register) (Units ltr) <CR><LF>
CODES - 65 CODE, 80 CODE, 87 CODE, 58 CODE, 32 CODE, 141 CODE,
32 CODE, 149 CODE, 13 CODE, 10 CODE [to add line feeds enter 10 CODE here; to add
a form feed enter 12 CODE here.]
DONE [to end script]
Each time the PRINT soft key is pressed (followed by the Print Register # if not the default), the scale will
output the above ASCII format and advance the printer to the next line or label.
Entering a Script using a QWERTY Keyboard
Simple scripts, such as the ASCII output above, can be more easily programmed by connecting a QWERTY
keyboard to the Super II controller. By using a combination of typed characters and numeric codes, the
entire script can be entered using the QWERTY keyboard.
Before a script can be typed in using a QWERTY keyboard, the scale must be setup to accept the format-
ting characters and programming codes. To perform this setup, follow the instructions under soft key
PRINT in the Supervisor Setups section of this manual.
The following is the Script entry menu.
To produce the same ASCII output below, the script can be entered using the QWERTY keyboard. Type in
alphanumeric characters followed by the F1 function key or numeric formatting and scale registers codes
followed by the F2 function key.
ENTER CODE PC BARCODE GO BACK
Enter each code or character now. PC
to download script. BARCODE to scan.